Garage door won't close: sensor repair in Yonkers

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (914) 820-8522

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Yonkers repairs the sensors and re-tests the opener's safety system.

Opener, rail and torsion spring above a garage door with windows

Doors that won't close in Yonkers

Yonkers is hilly, and in Park Hill, Colonial Heights and Crestwood a great many garages sit under the house at the bottom of a steep drive. Slush and meltwater run down to the door all winter, the slab heaves, and the sensors end up at slightly different heights. If the door closes in dry weather and reverses when the floor is wet or icy, that is the reason. Older garages in Bryn Mawr and Dunwoodie are also narrow enough that a car mirror or bumper can clip a bracket.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Yonkers

  • Lawrence Park West and Cedar Knolls: Next to Bronxville, with larger houses and built-in garages.
  • Bryn Mawr and Dunwoodie: Mid-century homes near the golf course and the Saw Mill.

See the full Yonkers service area.

Garage door won't budge? Call first, force it never.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (914) 820-8522
Call (914) 820-8522